
Vickers 7000 Manual THE NEEDLEBAR Online Manuals Section VICKERS 7000 Vibrating Shuttle A. Introduction This machine has been thoroughly tested and inspected before leaving our factory and the following directions will be found sufficient to enable you to acquire a perfect working knowledge without any personal instruction. Whether or not you have previously used a sewing machine, in order to obtain the very best service from this model we strongly advise you to carry out all these directions, paragraph by paragraph, before putting this machine into use. To connect Hand Appliance Handle With the left hand pull out the handle bar piston, take the handle in the right hand, pivot it into position and release the handle bar piston. The handle is then locked in position and ready for operation. When you have finished work, the handle must be turned back again, by reversing the above procedure, before replacing the cover.
Vickers industrial hydraulics manual, 1992, 611 pages, Eaton Corporation,, 209, Eaton Corp. Training, 1992 DOWNLOAD http. Finesse Sewing Machine User Manual Model 373. 3 Section I – Introduction A. Purpose of Manual This manual has been prepared to assist the users of Vickers balanced vane type hydraulic single pumps in. Vickers Industrial Hydraulics Manual [Vickers Training Center] on Amazon.com. *FREE* shipping on qualifying offers. Eaton Fluid Power Training's Industrial Hydraulics Manual have set the standard for the industry for many years. Vickers Industrial Hydraulics Manual [Vickers Training Center] on Amazon.com. *FREE* shipping on qualifying offers. Eaton Fluid Power Training's Industrial Hydraulics.

To connect the Fly Wheel to the Stitching Mechanism To prevent accidents to the working parts, always keep the fly wheel disconnected from the stitching mechanism when the machine is not in use. Avanset Visual Certexam Suite V3.1.1 License Key. To connect the fly wheel, turn the disconnector disc (A figure 1) on the fly wheel until the steel connector (B) is uppermost, turn the fly wheel until the slot (C) is in line with the steel connector, then press the connector into the slot and the fly wheel is connected to the stitching mechanism. To disconnect the fly wheel, pull back the steel connector.
To ensure perfect operation of the Machine The fly wheel must always turn towards you and the handle away from you. The presser foot (E figure 2) must be raised except when sewing. Do not work the machine with the shuttle and needle threaded unless there is material between the presser foot and the feed teeth.
The shuttle slide must be always be closed when sewing. To operate the Hand Machine To operate the hand machine, connect the fly wheel to the stitching mechanism, raise the presser foot (E figure 2) by lifting the presser bar lifter (D figure 2), place a piece of material under the presser foot, lower the presser bar lifter and turn the handle from you with an easy and regular motion. Continue to do this until you are able to guide the material correctly with the left hand. Map Updates For Navman F10. To operate the Treadle Machine Disconnect the fly wheel from the stitching mechanism, place both feet upon the treadle and turn the fly wheel towards you, at the same time allowing the feet to move freely and lightly with the motion of the treadle.